.jpg)
We are one of the leading Suppliers of Moisture Measurement Meter. Flush mount, digital, microwave Moisture Measurement Meter is accurately designed following the set industrial parameters. The Hydro-Mix VII is a rugged, microwave Moisture Measurement Meter designed to be installed flush with the floor of a mixer, chute or conveyor in process control environments. Reading at 25 times per second and combined with on-board functionality such as signal processing, smoothing and averaging, the Hydro-Mix VII Moisture Measurement Meter accurately measures the moisture content of material as it passes over the ceramic faceplate. Remote configuration, calibration, diagnostics and firmware upgrades are simple using Hydronix Hydro-Com software. The linear output allows direct integration with any control system using industry standard interfaces.
Moisture Measurement In Bulk Materials ( Hydroprobe-II ) : The ultimate intelligent microwave sensor for measurement of moisture in sand and free flowing solid materials in bins
Range of moisture : For bulk materials the sensor will measure up to the point of saturation typically 0-20% for construction materials
Penetration : Approximately 75-100mm dependent on material
Penetration : Approximately 75-100mm dependent on material
Power supply : +15Vdc to +30Vdc. 3 watts max
Refresh rate : Outputs are updated approximately 25 times per second
Refresh rate : Outputs are updated approximately 25 times per second
Analogue output : Configurable 0-20mA or 4-20mA current loop source For 0-10Vdc output an external 500R load resistor should be connected across the analogue output at the control system
Digital Communications : Up to isolated RS485 2-wire port